The use of automatic glass doors is very common in current life, whether it is household or corporate, we will see its presence. However, after using automatic glass doors, it is inevitable that some faults will occur, such as not automatically returning to the original position, which will affect the use of glass doors. Therefore, when installing them, it is necessary to pay more attention to details. Below, the installation and maintenance manufacturer of Jinan electric roller shutter doors will explain to you:
For the installation of automatic glass door, the upper and lower door shafts must be on the same vertical line. The glass door must use the steel structure beam as the skeleton, and the upper shaft must be welded on the beam. Because the upper shaft is the support point of the entire glass door, it must be firm. It is prohibited to use the fine wood board keel structure for the upper beam. Because the connection point between the upper shaft and the wood structural join can only use self tapping screws to fix the connection. Because of the large number of door opening times, Over time, the door shaft is prone to detachment, causing danger.
When installing the pre embedded ground spring for automatic glass doors, a rectangular square pit should be chiseled on the original ground surface, with the surrounding area being 10mm larger than the base of the ground spring. It is recommended to use the high grade cement mortar to fill it firmly. After 48 hours of cement solidification for the ground spring, it is recommended to install the glass door according to the glass door. The ground edge of the glass door should be 8-12mm away from the ground to prevent the glass door from rubbing against the ground when sagging.
The upper and lower door shafts of the floor spring door should be located in the center of the door frame, so that the automatic glass door can also be located in the center of the door frame after installation, achieving a beautiful effect. After installing the glass door, it should be 3-6 millimeters away from the crossbeam to prevent the connection between the door shaft and the door clamp from detaching when the door sags. There is also a detail to note that butter should be injected into the position between the door shaft and the door clamp to reduce wear on the connection and extend its service life.
Metal accessories for glass doors, such as handles and door edge metal strips, can be replaced directly if they come off or are damaged. If there is a problem with the floor spring, it is recommended to have a professional glass door repairman come to your doorstep.
Glass is very fragile and extremely difficult to repair. The idiom "broken mirror is difficult to round" that has been circulating in China indicates that glass can break and its repair is basically impossible. Moreover, with the increasing use of glass doors, there will always be some major or minor malfunctions during long-term use, which will affect the overall effectiveness of glass doors. Therefore, when encountering faults, it is necessary to handle them in a timely manner to extend the service life of the glass door as much as possible.
If the glass door fails to slide normally during use, it is necessary to check if there are impurities in the sliding groove that prevent it from sliding normally. If so, clean the impurities in the sliding groove to see if it can slide normally. If not, check if the chute is rusted. In this case, add some lubricants or lubricants to the chute or remove rust from the chute.
Glass doors are widely used in our daily lives, mainly for their beauty and convenience, but they can also be relatively fragile to use. So when using us, we need to be careful and take care of it. If there are any problems, we need to repair them in a timely manner. For more related content, please visit our website http://www.jnyuqilin.com Consult!