电动卷帘门的保养要注意什么?
1、在电动卷帘门的使用过程中,要尽量保持控制器和电压的稳定,禁止安装在非常潮湿的环境,另外不要随意打开遥控器,如若发现门体上有电线缠绕、打结等应及时处理。注意通道的是否堵塞,阻碍门体下降,如若发生异响应立即停止电机运作。
1. During the use of electric roller shutter doors, it is necessary to maintain the stability of the controller and voltage as much as possible. It is prohibited to install them in very humid environments. In addition, do not open the remote control arbitrarily. If any wires or knots are found on the door body, they should be dealt with in a timely manner. Pay attention to whether the channel is blocked, which hinders the door body from descending. If there is an abnormal response, immediately stop the motor operation.
2、要经常性的检查电动卷帘门上下行程的开关,对行程控制器加上润滑油,保持正常良好的运行,另外,操作人员手动控卷帘门,检查器运行情况,校对上下行程开关位置,使电动卷帘门开启或关闭时处于适当位置,且检查过程中严防电动卷帘门冲顶或冲底或者反转,如若出现紧急情况应立即停止转动,切断电源。
2. Regularly check the up and down travel switches of the electric roller shutter door, apply lubricating oil to the travel controller to maintain normal and good operation. In addition, the operator manually controls the roller shutter door, checks the operation of the device, and calibrates the up and down travel switch positions to ensure that the electric roller shutter door is in the appropriate position when opened or closed. During the inspection process, strictly prevent the electric roller shutter door from hitting the top, bottom, or reversing, If an emergency occurs, immediately stop rotating and cut off the power supply.
电动卷帘门安装方法是什么 电动卷帘门有什么安装方法
What is the installation method for electric roller shutter doors? What are the installation methods for electric roller shutter doors
3、操作员是经常性的要检查好电动卷帘门的手动开关和手动升降装饰,以防止在紧急的情况下电动卷帘门会失灵,或者造成不必要的事故。
3. It is best for operators to regularly check the manual switch and manual lifting decoration of the electric roller shutter door to prevent it from malfunctioning or causing unnecessary safety accidents in emergency situations.
4、要保持轨道运行畅通,及时清理电动卷帘门的轨道,保持内部清洁,卷帘门电机和传动链条要经常加注润滑剂,检查控制箱内器件和开关控制盒,紧固接线端口,紧固螺丝等,清洁控制箱内、表面和按钮上的灰尘污物,防止按钮卡住而不能反弹。
4. To maintain smooth operation of the track, clean the track of the electric roller shutter door in a timely manner and maintain internal cleanliness. The motor and transmission chain of the roller shutter door should be regularly lubricated, and the components and switch control box inside the control box should be checked. Wiring ports should be tightened, screws should be tightened, and dust and dirt on the control box, surface, and buttons should be cleaned to prevent buttons from getting stuck and not rebounding.