车库的电动卷帘门的安装过程如何？

经济不断的发展，生活水平不断的提高，家家户户都有了小汽车，对于拥有车的家庭必定有车库，那么车库的电动卷帘门的安装过程中有哪些需要注意的呢?济南车库门安装维修小编整理了一些关于车库的电动卷帘门的相关信息。

With the continuous development of economy and the continuous improvement of living standards, every household has a car. For the family with a car, there must be a garage. What should be paid attention to during the installation of the electric roller shutter door in the garage? Jinan garage door installation and maintenance team sorted out some information about the electric roller shutter door of the garage.

1、先在需要安装的门框框口位置画出线，表明尺寸大小，然后找工作人员设计出合适的电动卷帘门(注意:框内高度比门扇的高度要高一点)。

1. Draw a line at the opening of the door frame to be installed to indicate the size, and then find the staff to design a suitable electric roller shutter door (Note: the height inside the frame is higher than the height of the door leaf).

2、把电动卷帘门的门框固定，这里要先拆掉门框下部的固定板(注意:洞口两侧地面要预留凹槽，经校正合格后，固定木楔，门框铁脚与预埋铁板件焊牢。用水泥砂浆或强度不低于10MPa细石混凝土嵌塞牢固即可)。

2. To fix the door frame of the electric rolling shutter door, the fixing plate at the lower part of the door frame shall be removed first (Note: the groove shall be reserved on the ground at both sides of the opening. After the correction is qualified, the wooden wedge shall be fixed, and the iron foot of the door frame shall be welded with the embedded iron plate. It can be firmly plugged with cement mortar or fine aggregate concrete with strength not less than 10MPa).

3、安装电动卷帘门扇主体门扇。一定要保证电动卷帘门与墙体结成整体，封闭性要做好，再粉刷洞口及墙体。粉刷完毕后，门缝应均匀平整，开启电动卷帘门应该自由轻便，不得有过紧、过松和反弹现象。

3. Install the main door leaf of the electric roller shutter door leaf. Make sure that the electric roller shutter door and the wall form a whole, and the sealing shall be done well, and then paint the opening and the wall. After painting, the door seam shall be even and flat. The electric roller shutter door shall be free and light to open, and shall not be too tight, too loose or rebound.

车库卷帘门尺寸大小，主要依据门面房的高度和宽度来定。车库卷帘门几乎是不会受到任何限制的，其大制作高度可达到9米-14米，大制作宽度4米-12米。

The size of the rolling shutter door of the garage is mainly determined according to the height and width of the front room. The rolling shutter door of the garage is almost free from any restrictions. Its large-scale production height can reach 9 meters to 14 meters, and the large-scale production width is 4 meters to 12 meters.

常见的车库卷帘门尺寸:

Common garage roller shutter door size:

卷轴一般选用直径80mm的圆管，根据门的大小端座尺寸有所不同，以使用情况确定是否需要罩壳。一般小型的单车库门(宽度3m以内，高度2.5m以内)选用55型号或77型号的帘片，大型双车库门则选用77型号帘片。

Generally, the spool is a round pipe with a diameter of 80mm. The size of the end seat varies according to the size of the door, and whether the cover is required is determined according to the use situation. Generally, Model 55 or model 77 curtain shall be selected for small single garage doors (width less than 3m and height less than 2.5m), and model 77 curtain shall be selected for large double garage doors.

车库卷帘门是以多关节活动的门片串联在一起，在固定的滑道内，以门上方卷轴为转动上下的用于车库的门。车库卷帘门按照开关类型分为手动车库卷帘门和自动车库卷帘门。

The rolling shutter door of the garage is a door used for the garage, which is connected in series by multi joint movable door pieces and rotates up and down with the roller shaft above the door in a fixed slide. The rolling shutter door of the garage is divided into manual rolling shutter door and automatic rolling shutter door according to the switch type.

车库卷帘门能够大程度上的满足各种尺寸需求，具有很好的防护性能，不占用车库门内部空间，适用于商业门面、车库、、医院、厂矿企业等公共场所或住宅的车库。

The rolling shutter door of the garage can meet the needs of various sizes to a large extent, has good protection performance, and does not occupy the internal space of the garage door. It is suitable for the commercial facade, garage, shopping mall, hospital, factory and mining enterprises and other public places or residential garages.

安装车库的电动卷帘门，一定要办证电动卷帘与墙体结合整体的效果。封闭性要做好，再粉刷洞口以及墙体，粉刷完毕了过后，门缝还要均匀平整，这样在开启车库卷帘门过程中应该自由轻便，不会出现过紧，过松或者是反弹的现象。更多相关事项就来我们网站http://www.jnyuqilin.com咨询！

When installing the electric roller shutter door of the garage, it is necessary to verify the integrated effect of the electric roller shutter and the wall. The sealing shall be well done, and then the openings and walls shall be painted. After the painting is finished, the door seams shall be even and flat. In this way, the rolling shutter door of the garage shall be free and light in the process of opening, and there shall be no over tightening, over loosening or rebound. For more information, please visit our website http://www.jnyuqilin.com consulting service