电动卷帘门如果卷过了怎么办?
现在经常由于许多的卷帘门厂家生产出厂的卷帘门问题而给人们的生活带来不便的事情,从中
济南电动卷帘门安装维修人员发现,对于以前的一些帘门厂出产的卷帘门经常会存在一些问题。
Nowadays, many roller shutter door manufacturers often encounter inconvenience in people's lives due to problems with the rolling shutter doors produced by them. From this, the installation and maintenance personnel of Jinan electric roller shutter doors have found that there are often some problems with the rolling shutter doors produced by some previous roller shutter factories.
而对于这些问题我们就需要为之付出一些思考的问题,如果说我们每天都要碰到其中一些电动卷帘门卷过的情况,那么也就严重的影响我们的生活状况。那么对于这些电动卷帘门如果卷过了我们应该怎么办呢?
And for these issues, we need to put in some thinking. If we encounter some electric rolling shutter doors rolling over every day, it will seriously affect our living conditions. So what should we do if these electric roller shutter doors are rolled over?
你必须有足够高的梯子或者架子能够用手抓住卷帘门上面,同时要两个人配合。假如该电动卷帘门在半空中的话,那么二人同时把卷帘门卷到顶后,从滑道拉出来再往上卷、贴墙面放进去入道轨,拉一下看,应该没问题了。
You must have a ladder or shelf high enough to hold onto the roller shutter door with your hands, and two people must cooperate. If the electric roller shutter door is in mid air, then two people should roll it up to the top at the same time, pull it out of the slide, then roll it up, stick it to the wall, and put it into the track. Pull it up and see, it should be no problem.
也可以用管钳夹住卷帘门轴紧一圈,但是你必须二人配合好,两边螺丝不要一起松,要先松一面并用管钳夹住,后再松另一面在进行紧轴。
You can also use pipe pliers to clamp the roller shutter door shaft tightly for one turn, but you must cooperate well with two people. Do not loosen the screws on both sides together, first loosen one side and clamp it with pipe pliers, and then loosen the other side before tightening the shaft.
这种情况是属于弹簧的毛病,以后你要注意开门时用开门的钩子往上送到顶,不要让它随弹簧的惯性猛冲,否则还会犯毛病!
This situation belongs to the problem of the spring. In the future, you should pay attention to using the hook to lift the door up to the top when opening the door, and do not let it rush with the inertia of the spring, otherwise it will still cause problems!
此外使用期间,卷帘门电机连续卷动时间不得超过5-10分钟,因电机连续运转时间超过规定时间电机容易发热,若电机温度超过120℃,机内热保护器自行断电,待温度降到70℃(约8分钟)保护装置才能自动复位,方可继续使用。当出现上述现象时,一定要冷静分析,正确排除,切不可盲目拆卸,以免造成不必要的损失。
In addition, during use, the continuous rolling time of the roller shutter door motor should not exceed 5-10 minutes. As the motor runs continuously for more than the specified time, it is easy for the motor to heat up. If the motor temperature exceeds 120 ℃, the internal thermal protector will power off automatically. The protection device can only reset automatically when the temperature drops to 70 ℃ (about 8 minutes) before continuing to use. When the above phenomenon occurs, it is necessary to calmly analyze and correctly eliminate it. Blind disassembly is not allowed to avoid unnecessary losses.
That's all we have to say about the issue of electric roller shutter doors being rolled over. We hope to provide you with good help. For more information, please come to our website http://www.jnyuqilin.com consulting service