电动车库门安装需注意这五点

电动车库门，企业常用设施，适用于商业门面、车库、、医院、厂矿企业等公共场所或住宅。尤其是门洞较大，不便安装地面门体的地方起到方便、快捷开启作用。电动车库门安装需注意这五点，下面济南车库门安装维修厂家为您讲解。

Electric garage door, a common facility for enterprises, is suitable for commercial storefronts, garages, shopping malls, hospitals, factories and mining enterprises and other public places or residences. Especially where the door opening is large and it is inconvenient to install the door body on the ground, it can play a convenient and quick opening role. The installation of electric garage door needs to pay attention to these five points. Next, Jinan garage door installation and maintenance manufacturer will explain to you.

1、电动车库门须按说明书要求安装。其实不仅仅是卷闸门的电机需要按照说明书进行安装，对于门的安装事项也需要严格按照说明书进行，这样才能保证安装后能够正常使用。

1. The electric garage door must be installed according to the instructions. In fact, not only the motor of the rolling gate needs to be installed according to the instructions, but also the installation of the door needs to be carried out strictly according to the instructions, so as to ensure the normal use after installation.

2、确定安装水平线及垂直线，按设定尺寸依次安装。槽口尺寸应准确，上下保持一致，对应槽口应在同一平面内，然后用连接件与洞口内的预埋件焊牢。

2. Determine the installation horizontal line and vertical line, and install them according to the set size. The notch size shall be accurate and consistent from top to bottom. The corresponding notch shall be in the same plane, and then the connector shall be welded with the embedded part in the hole.

3、卷轴、文架板须牢固地装在混凝土结构上或预埋件上。宽大门体需在中间位置加装中柱，两边有滑道，中柱安装须与地面垂直，安装牢固，但要拆装方便。

3. The reel and document shelf plate must be firmly installed on the concrete structure or embedded parts. The wide door body needs to be installed with a central pillar in the middle, with a slide on both sides. The central pillar must be installed vertically with the ground and firmly, but it should be easy to disassemble.

4、安装完略，先手动调，自试运行，观察门体上下运行情况，正常后通电调试。观察卷帘机、传动系统、门体运行情况应启闭正常、顺畅，速度为3-7米/分钟。如果出现问题那么调整制动器外壳方向，使环形链朝下，调整链条张紧度，链条6-10mm，调整单向调节器及限位器，就可以使用了。

4. After the installation is completed, manually adjust it first, conduct self-test, observe the up and down operation of the door body, and then conduct power-on commissioning after it is normal. Observe the operation of the roller shutter, transmission system and door body. The opening and closing shall be normal and smooth, and the speed shall be 3-7 m/min. If there is a problem, adjust the direction of the brake housing so that the annular chain is downward, adjust the chain tension, 6-10mm, adjust the one-way adjuster and limiter, and then it can be used safely.

5、卷筒安装应先找好尺寸，并使卷简轴保持水平位置。注意与导轨之间的距离应两端保将一致，临时固定后进行检查，并进行要的调篷、校正，无误后再与支架预埋件用电焊焊接。后就是清理、粉刷或镶砌导轨墙体装饰面层，清理现场。

5. When installing the drum, first find the size and keep the winding shaft in a horizontal position. Note that the distance between the guide rail and the guide rail should be the same at both ends. After temporary fixing, check it, adjust and correct it, and then weld it with the embedded parts of the support by electric welding. After that, clean, paint or inlay the decorative surface of the guide rail wall, and clean the site.

综上所述，我们对于安装车库门时应该注意的事项有了比较深入的了解，您对此还有什么问题就来我们网站http://www.jnyuqilin.com进行咨询了解吧！

To sum up, we have a deeper understanding of the matters that should be paid attention to when installing the garage door. If you have any questions about this, please come to our website http://www.jnyuqilin.com Consult and understand!